#UNICODE COMMAND FOR BULLET POINT CODE#
#UNICODE COMMAND FOR BULLET POINT WINDOWS#

The 33 characters classified as ASCII Punctuation & Symbols are also sometimes referred to as ASCII special characters. The remaining 43 belong to the common script. See also: ASCII В§В ASCII printable charactersД©5 characters the 52 alphabet characters belong to the Latin script. Unix / Linux systems use Control-D to indicate end-of-file at a terminal.

#UNICODE COMMAND FOR BULLET POINT WINDOWS#

11 Control-Z has commonly been used on minicomputers, Windows and DOS systems to indicate 'end of file' either on a terminal or in a text file. 10 Control-X was commonly used to cancel a line of input typed in at the terminal. Other manufacturers used Control-X for this purpose. 9 Control-U was originally used by Digital Equipment Corporation computers to cancel a line of typed-in text. Output is suspended until restarted by the Control-Q key. 8 Control-S has been used to tell a host computer to postpone sending output to the terminal. 7 Control-Q has been used to tell a host computer to resume sending output after it was stopped by Control-S. Output is not sent to the terminal, but discarded, until another Control-o is typed. 5 Carriage Return (accompanied by line feed) is used as 'end of line' character by Windows, DOS, and most minicomputers other than Unix- / Linux-based systems 6 Control-O has been the 'discard output' key on minicomputers.

4 Line feed is used for 'end of line' in text files on Unix / Linux systems. This was carried over on PCs by generating a buzz sound. Important messages could be signalled by striking the bell on the teletype. 3 Control-G is an artifact of the days when teletypes were in use. Windows, DOS, and older minicomputers used Control-Z for this purpose. 2 Control-D has been used to signal 'end of file' for text typed in at the terminal on Unix / Linux systems. All belong to the common script.ДЎ Control-C has typically been used as a 'break' or 'interrupt' key. See also: ASCII В§В ASCII control characters, and Control PicturesД¦5 characters, including DEL. The semicolon is required.Д«ecause numbers are harder for humans to remember than names, character entity references are most often written by humans, while numeric character references are most often produced by computer programs. Where name is the case-sensitive name of the entity. The format is the same as for any entity reference: The entity must either be predefined (built into the markup language) or explicitly declared in a Document Type Definition (DTD). In contrast, a character entity reference refers to a character by the name of an entity which has the desired character as its replacement text. The hhhh may mix uppercase and lowercase, though uppercase is the usual style. The nnnn or hhhh may be any number of digits and may include leading zeros. The x must be lowercase in XML documents.

#UNICODE COMMAND FOR BULLET POINT CODE#

Where nnnn is the code point in decimal form, and hhhh is the code point in hexadecimal form.

A numeric character reference refers to a character by its Universal Character Set/ Unicode code point, and a character entity reference refers to a character by a predefined name.ДЄ numeric character reference uses the format HTML and XML provide ways to reference Unicode characters when the characters themselves either cannot or should not be used. See also: List of XML and HTML character entity references and Unicode input 12 Other south and central Asian writing systems.

Unicode command for bullet point